Now that Halloween is here, it's a great time to get creative and make yourself a wizard's hat and wand.
Follow our easy instructions and you too can look like Harry Potter!
WARNING: Scissors can be dangerous.
Make sure you ask an adult for their help before you start on your hat.
What you will need:
A large piece of black felt (one metre from a roll) A smaller piece of yellow felt (about a third of a metre) A pair of scissors PVA glue Double-sided tape White chalk or wax crayon Felt tip pen A small side plate for marking out the felt
Instructions:
Step 1 Fold out the black felt. Place the plate on the felt at one corner, making sure there is a two-inch border all the way around it. Mark around the plate with the chalk then draw a second circle 2ins from the outside your original circle.
Step 2 Cut out the circles along the marks you have drawn. (These will make the brim of the hat). Do this twice.
You should end up with two felt circles - looking a bit like a pair of spectacles.
Step 3 Cut straight along the cone shape at the base to neaten it off.
Step 4 Take the rest of the felt and make a cone shape. Fasten it together with double-sided tape.
Step 5 Along the bottom of the cone, cut slits up into it about two inches long and two inches apart. Then place a piece of double-sided tape on each segment.
Step 6 Take the point of the cone and pull it through the centre of one of the brim circles until it reaches the top of the slits. Fold over and stick onto the underside of the circle (brim).
Step 7 Take the other felt circle and put PVA glue around the top then stick it on the underside of the brim of your hat. This will sandwich all of the pieces together securing it better and it will stiffen the brim a little.
Step 8 Take the yellow felt and draw some stars and half moon shapes on it.
Step 9 When you have done a fair few, cut them out and start sticking them onto your hat using the double-sided tape.
